PS PRO SERIES PPF is warrantied for 10 years LIFETERM against a range of issues including yellowing. More information about the warranty can be found on our Warranty Information page

The PS PRO SERIES, GLOSS, MATT, and BLACK warranty is transferable to another owner with proof of purchase.

We offer a transferable LIFETIME warranty on both the PREMIUM, and SUPREME series. The warranty covers against cracking, peeling, bubbling, delamination, fading and color change for the life of the film. The warranty is transferable and will continue with the car even in the event the ownership change.

Our window film is designed to with a very strong adhesive for durability, upon removal of the window film the adhesive will not fully transfer to the film and will remain on the glass.

While you can wax the film, be sure the product you are using doesn’t contain Naphtha or Kerosene in concentrations over 5%, and also avoid waxes that contain dyes.

Yes, you can install a vinyl on top of the film. We recommend waiting 48 hours after installation before doing so. You may also remove the stripe without damaging the film, if removed properly.

Yes, Coatings can be applied to the films. Adding a coating does not stop the film from self-healing. Coatings can add a protective layer over the film, which depending on the coating can provide different properties (Please contact your installer or coating company for more information). That additional coating layer, depending on the coating applied, may or may not self-heal. Once the coating wears down and deteriorates, the self-healing qualities of PS PRO SERIES will still remain.

Yes. Factory paint is fully cured before the car ever leaves the assembly line.

You may use any standard car wash soap, rinse free car wash, or detail spray to clean the film, provided that the product does not contain more than 5% naphtha or kerosene.

Yes, pressure washers can be used on PS paint protection films, provided the film has completely dried after installation (typically 48 hours) and provided the high-pressure water is not pointed directly at the edges of the film.

It is highly unlikely for paint protection film to harm OEM paint. Paint systems used on modern assembly lines today produce a minimum bond strength of 16 MPa and maximum of 25 MPa between the panel and the paint depending on color, iridescence and the system used. Our film’s bond to the painted surface at normal state (immediately following installation) is .0753 MPa. Even after years of heat and sun, the bond between the film and the paint increases to only 0.17 MPa. What that means is in the absolute worst case scenario, the bond of factory paint to the panel is over 94 times stronger than the bond of our film to the paint. In the best case, the paint is 332 times stronger.

PS Paint protection film can be applied on any smooth painted surface. However, given the tight tolerances on weight, balance and other factors on some aircraft, it is highly recommended to consult with the manufacturer of the airplane for strict guidance.

YES

The clear coat is the self-healing layer and is approximately 25 microns thick. If that layer is penetrated, the film will not heal.